Vintage Mustang Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. Vintage Mustang Forum
    Hey, can anyone recommend a good driveshaft shop. I need a 58 & 5/8th inch shaft to mate to a 1330 series yoke and a 6r80 transmission with a factory flange. I prefer a 3 inch diameter shaft that can handle about 8000 rpm. been have a hard time trying to find a shop that is reasonable priced to...
  2. Mod and Custom Forum
    My 66 mustang is needing a new driveshaft. The current driveshaft is a 1 piece 2.5in steel shaft with 1310 u joints on it. With the T5 in the car and the 4.11 rear gears, I am experiencing a driveline vibration at 80mph that gets far worse the faster you go. I did some mathematical calculations...
  3. Vintage Mustang Forum
    I have a 1965 Ford mustang 200 six cylinder automatic with a c4 and stock rear end. I installed a new u-joint in the rear and I am tightening down the u-bolts but they are not holding the u-joint firmly. Is this normal? I don't think so. Am I supposed to install the clips in order to hold the...
1-3 of 3 Results
Top