Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE

mustang 69

  1. Vintage Mustang Forum
    So now I think only 1 problem to fix before I can put the car on road. This is what I’m facing now. I recently changed my intake and had to take the dis out. Now I can’t seem to figure it out. My balancer doesn’t have timing written on it. So when I did try to put the dis back in after finding...
  2. Vintage Mustang Forum
    I recently got EdelBrock super victor intake. It’s not fitting properly. One side sits then other side doesn’t sit. I don’t know if this is possible but can you grind the head down a bit to make it fit? Or that’s a no?!?!
  3. Vintage Mustang Forum
    I have a mustang 66 and it has a 302 engine in it. Ever since I started the car it’s not turning off with the key. It turns on with the key but not off. I’m running the wire for coil from ignition ( red wire) is that why it’s doing that? If so then where should I run the coil wire from?
  4. Vintage Mustang Forum
    I’m very concerned about my balancer does anyone know why my balancer is shaking a bit? When I idle the car the balancer feels spinning funny and not spinning solidly. I have a mustang 66 and it has a 302 in it. Please help because I’m very concerned. I don’t think I can upload a small clip...
  5. 1969 through 1970 Mustang Parts For Sale
    Hello Everyone, I have a mustang 66 and I recently put 302 engine in it. When I got the engine it didn’t have eccentric and correct timing cover for mechanical fuel pump to go in. So I bought 69 mustangs timing cover and stuff. I installed 1 piece eccentric and it wasn’t rotating at all and...
Top