Vintage Mustang Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 9 Results
  1. 1964 1/2 through 1966 Mustang Parts For Sale
    I have a very nice 66 Mustang convertible with 289 2bbl, engine,C4 Transmission, 8" rear end, front 8 cyl brakes drums and plates,Engine and transmission are fine. I drive the car everywhere. The engine is 100% w/air cleaner, A/C Compressor,P/S pump and lines and slave cylinder and...
    $2,000 USD
  2. Mod and Custom Forum
    Hey so I found a 9 inch rear end for cheap and it measures 40 and a half inches from center to center of the leaf spring perches. And I wanted to know if it would be a direct bolt in for my 1968 base
  3. Vintage Mustang Forum
    hi im installing dutchman axles into a brand new 9 inch rear end with a currie true track third member. is there anything special i have to do to install the axles or anything else i need? or can i just push the rods into the housing and bolt down the retaining clips
  4. Mod and Custom Forum
    Hey so I'm looking into swapping my rear end out of my 1968 mustang base and I found a guy who has a 9" rear end out of a 1969 cougar for 200$. I just wanted to know if it would be a direct bolt in? He also has a 8" out of a 1967 cougar but I'm not sure what the 8" is rated for since I'm going...
  5. Vintage Mustang Forum
    I already hear everyone screaming bloody murder over tossing originality out the window, but I intend to keep all the original stuff protected and stored. It's a 200 i6 coupe with a 3 speed auto and an open diff. All original currently with <60k original miles. I'm the second owner. End goal...
  6. Vintage Mustang Forum
    Hello all, I am taking apart the old gal to have her blasted and painted finally. Doing so, I realize that I have neglected the rear end in the car this entire time! The 289 2bbl has been rebuilt with a mild cam and the C4 transmission has been rebuilt as well. The rear is a...
  7. Vintage Mustang Forum
    I bought a 66 mustang as my high school project to take to college with me. It was original a 200 straight 6 and I am swapping to a slightly modified 302 (gt40 heads, flattop pistons, etc.). My budget is very low and was curious if it'd be possible to keep the 8 inch rear axle and put a stronger...
  8. Vintage Mustang Forum
    Hi Everyone, Need help in identifying this Rear End is it a 8.8 or a 9 inch. Thanks
1-8 of 9 Results
Top