Vintage Mustang Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. Vintage Mustang Forum
    First of all thanks for this great forum and the wealth of information being shared here. So finally found a car that I am interested in. 72 convertible with a 302 and FMX pretty much a one owner car with 66000 documented miles. I would love to to restore the car to a driving condition so safety...
  2. Vintage Mustang Forum
    So here's the deal, I recently spotted rust building under the rear quarter panel of my '68 coupe. As I began to explore, it spreads to the panel under the rear windshield. With some light work with a dremel near the corner of the rear windshield, I found that it goes all the way through the...
  3. Vintage Mustang Forum
    Hello Everyone, Just wanting to get some thoughts if it would be safe to repair the rust I have in my trunk. There is a patch that is near the gas tank.. I plan on using fibreglass strips and resin then applying bondo. There is also a spot near the rear right wheel well. I have attached some...
  4. Vintage Mustang Forum
    Had my 351 block worked on at a shop last September and this past weekend I took it out of my storage unit and found rust in some spots. No signs of water getting into the unit. I had put a ton of ATF over everything so this was a surprise. I recommend any one else in the north east to grease...
  5. Vintage Mustang Forum
    Hey all, I just found out that I'll be living in Hawaii for the next ~3 years for work. Currently I daily drive my rust-free '65. It would kill me to give it up but I'm young and won't be able to afford an enclosed garage (maybe a covered parking area) and I'm worried that the salt air and rain...
  6. Vintage Mustang Forum
    Hello everyone, This is my first post here. I’m looking to get my first Mustang, and looking to get some dumb questions answered. TIA. I’m exclusively looking for a 67-68 Fastback. I’ve been reading a lot of threads here to learn more about what I should be looking out for. There are not a...
  7. Vintage Mustang Forum
    Hi all, Back in May I purchased a 66 Convertible on eBay from MI and shipped it to CA. I trusted what I was buying based on the amount of detail that was in the eBay listing, as well as talking to the PO on the phone and email. I spent months looking a project car with all metal/body work...
  8. Vintage Mustang Forum
    68 Mustang Fastback I’ve got some rust on my floor pans in a couple of spots. It doesn’t (yet) appear to be too bad, but my question is, are these spots small enough for a cut and replace or should I be looking at replacing the whole floor pan? The top 2 photos are the drivers floor and the...
  9. Vintage Mustang Forum
    This is the seat back for my 64 1/2 Mustang. I know I can remove the rust, weld the crack and paint it. The seat base is similar (no cracks). I'd really like to salvage them both if I can. What I need to know is: will it be safe?
  10. Vintage Mustang Forum
    I am planning to make my engine bay look optimal and protect it. I have a 66 coupe. I have minor rust in the engine bay. Is there a way to treat this without major interventions? Which products and tools do I use?
1-10 of 10 Results
Top