Vintage Mustang Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. Vintage Mustang Forum
    Hello. Trying to adapt a 1987 trans yoke to a 1966 driveshaft due to the 1966 yoke being too long. The 1987 u joint is stuck, but I think I can get it out with some heat and convincing. My question is, what is the rubber ring that is on the 87 trans yoke between the splined section and the...
  2. Vintage Mustang Forum
    I have a 1965 Ford mustang 200 six cylinder automatic with a c4 and stock rear end. I installed a new u-joint in the rear and I am tightening down the u-bolts but they are not holding the u-joint firmly. Is this normal? I don't think so. Am I supposed to install the clips in order to hold the...
1-2 of 2 Results
Top