Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 8 of 8 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter · #1 ·
One set of original factory 14" steel wheels to fit '64-1/2 through '67 Mustangs with the 4-lug hubs (6-Cylinder cars). These are dated coded from 1964 and 1965 (see pictures). They have been dip stripped and e-coat primer dipped. So they have zero rust and a very good corrosion coating. This process cost most of what I'm asking for these wheels...

Nothing has been mounted on them since they were e-coated. Ready to install as is.

$350 + shipping.
 

Attachments

·
Registered
1965 Mustang Coupe plane Jane 6 cyl manual
Joined
·
183 Posts
Bummer. Shipping is going to be cost prohibitive for me, and you're not in the path of my upcoming drive/move from SoCal to FL.
 

·
Premium Member
1966 mustang convertible sprint 200, manual steering and brakes
Joined
·
235 Posts
Hi Keith, I’m in SE Michigan as well (Brighton). Are you planning to sell any other 6 cyl parts ? I may be in the market for a 200 engine or head soon.
 

·
Registered
Joined
·
31 Posts
Discussion Starter · #8 ·
Hi,
Probably not much... almost done with the car and don't really have a lot of "leftovers". Thx-
 
1 - 8 of 8 Posts
Top