C4 transmission out of 1965 Mustang w/ 289 V8. Asking $300. Rebuilt approximately 10 years ago, estimate 1000 miles on rebuild, and shifted fine when pulled out of car 6 months ago for 5 speed swap. Includes torque convertor, bellhousing, neutral safety switch wiring, and linkage. Should fit other classic Fords - casting numbers included for reference. Contact with any questions. Local pickup only, located in Kansas City.
Moderators I realized I put this in the wrong spot. Can you move it to the parts section?
Since my project is done, I'm unloading my left over stuff. Give me a reasonable price for each+shipping and its yours. Pictures below.
-65 engine mounts with original insulators (including the three...
I have an old Ford Motorsport M-6250-A312 camshaft and lifters I never ended up installing, I've decided to store the original engine and build a from a roller block. It's a Flat Tappet cam, 214/224 duration @ .050, .472/.496 lift. I don't want to see it go to waste and thrown out, so $50.00 ?
Took this out of my 66 convertible. Free to a good home if you come and get it. I'm just outside of Providence,RI Complete with torque converter, flex plate, load-spreader ring, engine plate, and inspection plate. I will even throw in the trans crossmember if you want. You will need a new...
Edelbrock 1403 4bbl 500 CFM carburetor. Like new. Only used for about 500 miles. Ran very well. Selling because I’m switching to a Holley Sniper EFI.
$250 local pick up (near LAX airport)
$275 shipped
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!
