Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 4 of 4 Posts

·
Premium Member
Joined
·
2,150 Posts
have several65-66 OEM used 4 speed driveshafts.They will be in good condition as they were taken off vehicles in the late 70's and early eighties. According to my K code book ,other than a bigger U joint that will work on a driveshaft for a 4-speed with an 8" carrier They are NOT K code specific as far as anything else.Let me know Thanks , Bob at [email protected]
 

·
Registered
Joined
·
1,715 Posts
The K code shafts ARE specific and shorter than the ones for an 8" . Been there done that. I would have to check my MPC for the exact overall dimensions.
 
1 - 4 of 4 Posts
Top