1967 Heavy Duty Suspension
Join the discussion
Recommended Reading
-
Does "numbers matching" really matter?
Vintage Mustang ForumI have a 1967 convertible with (as far as I can tell) the original 289/C4 combo. The paint is not correct to the vin and I have already upgraded to a 4bbl intake/carb, front coilovers and wilwood disc brakes. I am tossing around the Idea of a 351W/T5 swap. At this point, does it matter that I am...- 15
- 127
-
cmfle · updated
-
removing silicone
Vintage Mustang Forumhello previous owner siliconed the trunk gasket to the trunk. i was able to remove 60 percent via finger rubbing. the rest is really hooked up. 2 questions. can I remove it with out harming the top coat of paint ? if not can I paint over it with POR 15 top coat enamel ? - what is the best...- 6
- 226
-
67Pawling · updated
-
Valve terrain geometry and push rod length.
Vintage Mustang ForumI’m going through the process currently. I’m using this video as the procedure. I have basically a stock 289. Cam information is below. I’m changing to Pro Comp roller tip rockers. My first issue is which push rod length checker do I need. I need a base line. I know stock push rods are...- 24
- 586
-
Stangfire · updated
-
GT-A paint Stencil
Vintage Mustang ForumHey guys I had some damage to my front fender recently and I’m trying to get it fixed, it did chip the paint where the white strip is running down the bottom of the fender right before the tire, I’m trying to figure out where I could get a stencil that says GT-A on it so I can repaint the area...- 5
- 110
-
Antman68stang · updated
-
1967 stone guard supports?
Vintage Mustang ForumAnyone have a photo of the '67 stone guard supports installed? I can't find a drawing or representation anywhere.- 4
- 77
-
j persons · updated
Join now to ask and comment!