Vintage Mustang Forums banner
1 - 1 of 6 Posts

· Registered
627 Posts
Discussion Starter · #1 ·
I pulled my strut rods out of the "pulled from the car and might still need" pile
and noticed that one was slightly bent. Then I noticed that one of them has a
tapered end with a hole drilled through for a cotter pin and the other one doesn't.

Which is correct for a '67 'vert?

'67 C-code 'vert (Dees67)
'69 GT FB (project car)
Check out my band
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.