Vintage Mustang Forums banner

1 - 3 of 3 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
Can someone tell me the exact location of the hole and size of the hole , in the firewall , for the clutch pedal rod for a 1969 mustang. Converting from auto. trans to manual. Thanks
 

·
Registered
Joined
·
4,928 Posts
When I did this on my 70 fastback there was a dimple in the firewall where the hole needed to be. I used a hole saw to cut the hole and the dimple was my pilot. Hope this helps.
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #3
Thanks for the response, but what size is the hole ? Also looked on my car & I don't see the dimple . Anyone out there have the measurements on where to drill the hole ? Thanks
 
1 - 3 of 3 Posts
Top