Have a rectangular clock to install in my 1969 passanger side dash panel and need to know how the wiring set up and install point in the harness may be. If you have one or remember during a recent restoration. Would like to hear for you. Thanks in adance
1969 Mustang VMF'ers Clock help
Join the discussion
Recommended Reading
-
Best outdoor car cover (weather resistant)?
Vintage Mustang ForumBreaks my heart but my '68 coupe has to spend the winter outdoors, in CA it's not that bad, however I want to protect it from RAIN, sun, etc. Did some searching here and the posts were very old or from the manufacturers - would love to hear all your fave brands, good/bad experiences and also the...- 9
- 212
-
'Race Ramps' for service work
Vintage Mustang ForumAnyone use the Race Ramps Cribs for work underneath your car?- 18
- 466
-
ginpunk · updated
-
Electronic problems
Vintage Mustang ForumHello everyone: I've got a 67 fastback with a 289 4bbl and 4speed toploader. I've got a tribute tachometer in place of the am/temp guage that was working at one point along will all other electronics. One day the tach quit along with the turn signals, fuel gauge, temp gauge, heater fan and...- 4
- 216
-
Comp Numbers 66 289 with Twisted Wedge 170 61cc
Vintage Mustang ForumTrying to do some compression number calcs to see if these heads would be a good fit for my 289. Currently a stock 66 289. Twisted Wedge 170 w/ dual springs and 61cc chambers What's the stock comp #s with factory heads? What would the comp be with the 61cc chambers on the TW? Plans are for a...- 18
- 362
-
cturboaddict · updated
-
Any opinions on these seats?
Vintage Mustang ForumI currently have a bench seat. I realize they are rare and when I owned my 65' back in the 80's everybody would ooh and ahh when they saw a bench seat. I prefer the buckets any day over the bench seat...but I will keep the bench seat because it is rare in the garage for people to sit on. So I'm...- 26
- 2K
-
Shinobi68 · updated
Join now to ask and comment!