1970 Mustang Body tag codes.
Join the discussion
Recommended Reading
-
Bleeding brakes. Frustrated, got to vent.
Vintage Mustang ForumSo I'm trying to bleed my brakes after replacing my master cylinder. I got a 65 6 cylinder with four wheel drums. I've gone around the car 5 times trying to get the brakes bled. I'm doing it with my wife doing the press, open, close, release method and got out all the big bubbles I could see...- 20
- 675
-
Roadtrip!
Vintage Mustang ForumHi Everyone, I've been reading a lot more than posting for the last few years, but that might change a bit considering my current undertaking. I'm roadtripping across the USA in my '69 Cougar. For those who don't know, the Cougar is basically a Mustang with different sheetmetal and a 3" longer...- 24
- 544
-
Carb issue (maybe?)
Vintage Mustang ForumHello there, My 66 289 2bbl has become hard to start. Tried starter fluid but no help. Once it does start, it will idle rough for a minute and then just shut down. In looking at the carb, I noticed the plate is always open and has a range of just about an inch. (See pic, that is as closed as it...- 4
- 177
-
67-68 A/C Vacuum Lines Through Firewall - Seal?
Vintage Mustang ForumIs there a seal or grommet around the two vacuum hoses through the firewall for the A/C valve and vacuum reservoir (see my index and middle finger)?- 5
- 158
-
Show me your engine bay!!
Vintage Mustang ForumSince my car is in pieces and I’m going to rebuild the 289, I need to get some ideas on how to “dress” the engine bay. I don’t want to end up with an abomination of blue, red, yellow, black and chrome - so pop your hoods! I’ll get it started ;)- 29
- 536
-
67_ksb · updated
Join now to ask and comment!