1970 Mustang Mach1 Registry Updated...
Join the discussion
Recommended Reading
-
MPG concern
Vintage Mustang ForumHi all! I didn't want to hijack the other thread I was looking in so I thought I'd start a new one. As others in that thread stated they are getting at least 20 mpg, but after some calculating I did when I filled up on Monday I found out I'm getting about 11. I don't have a lead foot, but will...- 27
- 369
-
guitarman584 · updated
-
Header Fit
Vintage Mustang ForumHey guys I have a 67 mustang with a 302 from a 68 and a c6 transmission from (not sure where). Here’s the things, I know a c6 is a bit bigger transmission so I’m not sure which headers to get. Should I go with shortys or long tubes? Anyone recommend any specific ones? Thanks!- 3
- 67
-
Tailshaft Bushing Replacement- 3 Speed
Vintage Mustang ForumCan the tail housing on a 2.77 3 speed be removed with the transmission in the car without the needle bearings for the output shaft falling into the case? I need to replace the tail shaft bushing and seal but I don't have the special tool to remove the bushing. Im thinking that if I keep the...- 1
- 28
-
Fitch · updated
-
Preparing for the Ethanol Apocalypse
Vintage Mustang ForumFrom what I understand, E-15 will replace E-10 in a couple of years leaving us with only E-15 and E-85 to choose from. There will be some rare exceptions that will offer Ethanol-free gas but, it will be even more expensive than it is now. In my area, 87 octane Ethanol-Free gas is about $1.20...- 39
- 1K
-
Fitch · updated
-
Engine build
Vintage Mustang ForumNot planning on doing anything until the fall/winter, but I'd like to do my research and plan ahead. Going to pull out my 289 and do "something" to get more horsepower. I know I could drop in crate motor but what's is the fun in that. Looking to upgrade the 289, going to keep the C4 and the...- 16
- 465
Join now to ask and comment!