Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
322 Posts
The backside of the pressed pins are mushroomed like a rivet. You will need to grind the head flat and the press (with a hammer and punch) the pin out of the cast iron piece. The new kits have a threaded end with a nut. Hope that helps.

Steve
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top