Vintage Mustang Forums banner

1st VMF party

Jump to Latest Follow

1 - 1 of 1 Posts
PonyDoc

·
Registered
Joined
·
2,586 Posts
Discussion Starter • #1 •
I just spent the afternoon at my 1st VMF party and had a great time! Dinosawnj threw a little "get together" with a few other VMF'ers and it was a lot of fun. Interestingly enough, all present had 65-66's!! These should happen more often, so when this assignment is over and I get back to So Fl, I'll have to have one also!! ::
 
1 - 1 of 1 Posts
Recommended Reading
Read More

  1. Subframe Connectors-Your Pick?

    Vintage Mustang Forum
    Hey folks. Quick question for you all..... What is you preffered sub-frame connector for a 1967-68 coupe? Having searched all around I feel like the Detroit Speed version is what I will choose. But, I also like the TCP setup with a eye down the road for their whole bracing kit. My fear with...

  2. Keep or lose spring guard and bump stop?

    Vintage Mustang Forum
    Doing body work now and going to paint the engine compartment and wheel wells soon, so I’m wondering if I should remove the large panel covering the top of the coil spring? Or is that a terrible idea? I have future plans for coil overs, but for now I will just be upgrading stock style...

  3. Brake Education Needed - Rotor size vs Pistons

    Vintage Mustang Forum
    Hey everyone, I'm looking for a little education here. I'm wondering what's more important when it comes to stopping power: Rotor diameter or No. of pistons/piston volume... I am looking into the future disc brake upgrade and have been looking at the 13" cobra upgrade using Mustang Steve...

  5. Another Temp Gauge Problem

    Vintage Mustang Forum
    So, I got a 1966 289 and the temp gauge just isn't working. I tested before buying any parts by grounding out the wire that goes to the sender and I get full deflection on the gauge. Which, from what I've looked up that then means the gauge is most likely fine and its the sending unit. I also...

  6. Recommendations for a New Driveshaft?

    Vintage Mustang Forum
    After reading this .pdf from a 2014 post on this board I'm fairly sure that a standard 289 v8 coupe came with the rubber isolated drive shaft. Starting to lean towards putting re-balancing money (100-150$) towards a new driveshaft while pursuing other avenues of the vibrations. I've found that...
Read More
About this Discussion
0 Replies
1 Participant
Last post:
PonyDoc
Vintage Mustang Forums
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!
Full Forum Listing
Explore Our Forums
Vintage Mustang Forum General Discussion (Non-Vintage Mustang) Mod and Custom Forum Classic Mustang Wanted Ads Concours Forum
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Top