Vintage Mustang Forums banner
1 - 3 of 3 Posts

Discussion Starter · #1 ·
I've seen 2.5" exhaust systems, does anyone know if anyone make anything larger, other than custom made.

16,014 Posts
Hey Dave,
Where in CT are you from. I'm in Milford.

On the exhaust, good luck. I know that it is very difficult to get 3" pipes over the rear end. I have seen it ONCE, but that size pipe usually means turndowns. I know from looking around myself, there is no one in CT that does true mandrel bending.

[email protected]
1967 351W Convertible
2000 Mustang GT
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.