Vintage Mustang Forums banner

1 - 2 of 2 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
I have a running 200 cu.in. 6cyl out of my '70 coupe, complete with rebuilt Carter YF carb (has adapter plate under it?), also have brake drums and parts for 6cyl 4 lug from same car in near-new condition(or whole rear end, 2.75 open). Will part out any or all parts.

I need a pair of 289 heads (or at least one good one) or other small block heads with guide plates. Also need any small block perf. parts.
 

·
Registered
Joined
·
280 Posts
BlueOvalMan,

Am interested in knowing the following about the 200 cid engine: (1) do you know its last rebuild date approximately, and (2) what are you asking for it?

Thanks,

Kevin Christof
Santa Monica, CA
 
1 - 2 of 2 Posts
Top