Vintage Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Does anyone know where to buy a sfi approved flexplate for a 351 cleavland with a c6 out of a 73 cobra jet motor? The converter has 4 studs. Center of stud to center of stud is roughly 9.5 inches. All the ones at summit, jets, mustangs unlimited are the 11 7/16 bolt pattern.
thanks
 

·
I won a special award
Joined
·
7,409 Posts
Does anyone know where to buy a sfi approved flexplate for a 351 cleavland with a c6 out of a 73 cobra jet motor? The converter has 4 studs. Center of stud to center of stud is roughly 9.5 inches. All the ones at summit, jets, mustangs unlimited are the 11 7/16 bolt pattern.
thanks

If there is one still made, I seriously doubt it's going to be SFI approved.
 

·
I won a special award
Joined
·
7,409 Posts
Just get a converter designed for a standard 351C flexplate. You can get them with the same stall as the CJ C6 converter.
 
1 - 4 of 4 Posts
Top