Vintage Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,704 Posts
Discussion Starter #1
My 5.0 roller engine is ready to be installed in my '66. But I'm uneasy, with the cam and spring kit that I'm using, about the stock rocker arm bolts. Are there good aftermarket bolts for this application? Anyone have a part number?
 

·
Registered
Joined
·
10,961 Posts
likewise I swapped mine over from the P heads to a set of Edelbrock Performer 5.0 heads with .575 lift springs, the B303 conducting the orchestra
 

·
Registered
Joined
·
383 Posts
Not to highjack the thread but while your talking about roller rockers I'll show you my roller lifters. I bought a 1915 Mack truck project, two of them. Look at the lifters. I'm almost positive the rating on the trailer was just a suggestion. I didn't have very far to go and the bow in the trailer sprung right back after the 20,000 lb. truck rolled off of it. When I pulled the side cover I was could not believe they had roller lifters in 1915. No oil pumps but roller lifters. That engine weights about 1000 lbs. and puts 40 horsepower with a top speed of 15 mph

746504
746505
746506
 
1 - 4 of 4 Posts
Top