Joined
·
1,420 Posts
Can anybody tell me what pounds to torque the head bolts to and what the pattern is for the '66 200 6-cylinder? E-mail if you know.
Thanks
Thanks
6-cylinder 200 head bolt torque specs?
1 - 3 of 3 Posts
Joined
·
1,420 Posts
Thanks. 75 is what I figured, just needed somebody to back me up.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Runs flawless, then doesn’t.
Vintage Mustang ForumNot sure how common of a problem this is. Started her up on the second crank, drive about 15 mins, had it sit. Got back in, started on the first crank, drove another five minutes (all my car buddies live really close to each other, it’s really weird), and stopped for 20 mins. Started again...- 4
- 100
-
My rear breaks saga
Vintage Mustang ForumHi All So I'm replacing my rear brakes, y'all helped me eval the old in a recent post, and now I'm replacing them. But i have some issues. So I thought I'd start asking. I bought the off the shelf rear drum set of self adjuster, springs and pads. But I see some inconsistencies between what i...- 28
- 685
-
DoctorC · updated
-
65' Mustang
Vintage Mustang ForumThinking about taking out the 302 and putting in a more modern engine. That being said what is the most modern engine I can install without removing the shock towers? thanks a million.- 20
- 440
-
lucasp · updated
-
Will the Hayden 2947 Clutch Work With a 6-Bladed Fan?
Vintage Mustang Forum1970 Mach 1 with 351 Cleveland My fan sits too far into the shroud. It doesn't pull enough air at idle and the engine gets progressively hotter if the car is not moving. I want to install a shorter/low-profile fan clutch to move the fan back a bit. It looks like the Hayden 2947 is the...- 3
- 132
-
Eddie Motorsports vs Scott Drake 6 gauge instrument billet cluster
Vintage Mustang ForumConsidering buying an aluminum 6 gauge instrument cluster for my 65. How is the fit on them when mating with the metal dash? Are they really that much better than the plastic reproductions?- 1
- 98
Join now to ask and comment!