Vintage Mustang Forums banner

'65 2+2 passenger window

542 Views 1 Reply 0 Participants Last post by  Guest
G
Hmmmm, window is smooth and in the track but stops about 3"short of being fully recessed in the door when rolled down. -Just want a clue or 2 before I go monkeying around in there. -Thx.
1 - 2 of 2 Posts
G

·
Discussion Starter · #2 ·
Had similar problem with a customers car not too long ago. The chrome trim on the belt line w/strip was bent. As the window came down the trim would bind against the stainless trim on the glass. Just a thought , you might check this before pulling the door panel. Good luck, Chris
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top