Vintage Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
I need the following items for a 65-66 convertible
the sheet metal that goes behind the back seat, it's like an upside down V, where the top lowers into.
the hump that goes across the floor.
the top, just the frame will do, no power, just manual.
any of the stainless trim around the back and the front.
the section between the trunk lid and the top. you can see it when you open the trunk and look under.
Basically I need a convertible donor car. wrecked, rusted, or demolished I don't care. Any thing will help.
thanks
kevin
 

·
Registered
Joined
·
100 Posts
Don't forget, the pass and 1/4 windows may be unique for your convertible. 67/8 converts are different than coupes.
 

·
Registered
Joined
·
369 Posts
I have the rear stainless trim (middle, long piece, with holes for the boot trim) $40

I also have a complete set of convertible door/quarter glass $375.00 for all four pieces.

I also have several pieces of the windshield trim as well. $30 a piece.

Email me directly: [email protected]
 
1 - 6 of 6 Posts
Top