Vintage Mustang Forums banner
1 - 4 of 4 Posts

· Registered
12,251 Posts
Discussion Starter · #1 ·
Picked this car up in May '20, and am finally getting to it. My very lofty goal is to have it running and driving by the first week of May. I have other fish to fry at this time, so it'll be going up for sale, unless I get really attached to it. Floors are completely gone, as are rear torque boxes, but that's about it for rust.

Wheel Tire Car Vehicle Land vehicle

The floor, or what's left.....

Steering wheel Motor vehicle Vehicle Automotive exterior Gas

Currently, I have the passenger floor out, and am fitting the sorry excuse for a torque box. I had to cut it in half to get it to fit properly. I hope to have this fulley welded in and the te board installed tomorrow, then on to the driver's side t-box.

Tire Automotive tire Motor vehicle Bumper Automotive exterior
1 - 4 of 4 Posts