Vintage Mustang Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
66 Posts
Discussion Starter · #1 ·
Million dollar question here.
I purchased a set of rust free doors. However it looks like some one decided to sand the inside of the door panel area and primer it :chainsaw: . Some of the camera case rough finsh has been removed. How does one get this finsh back?
 

· Registered
Joined
·
2,931 Posts
You might be ok if the area sanded is going to be behind the door panel but if not, I think Midlife had a procedure where one uses a milk carton to roll on wet paint. A close simulation, I think, but I'm sure there are better procedures out there.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top