Vintage Mustang Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
496 Posts
Discussion Starter · #1 ·
1965 FB, Pony Int.
I have a hole in the front door jamb on both sides.
The drivers side has a grommet with 2 cut off wires coming out of it, the pass side is just a raw hole.
There are no matching holes in my doors but I know they are not original to the car.
Was there some additional Decor group door lighting that I'm missing? If so anyone got photos and/or location and size dimensions?

John
 

·
Registered
Joined
·
3,102 Posts
There were courtesy/safety lights near the bottom rear of each door. I do not have pictures I can send, but repros are sold in most Mustang catalogs. They should include a template. I could give you the door hole location near the front door post if that would help. You will also need a new wiring harness to run from inside to the rear of the door.
 

·
Registered
Joined
·
496 Posts
Discussion Starter · #3 ·
Yes, please tell me the location and size of the door holes.

Thanks
John
 

·
Registered
Joined
·
3,102 Posts
Will try to remember to do that tomorrow. Bug me by PM if you don't hear from me. Monday is going to be busy. I would not punch the holes until you have the actual wiring harness because the molded on grommet may be different from stock. Mine is a '66 with original pony interior. Have had the car since '67.
 
1 - 4 of 4 Posts
Top