Vintage Mustang Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
209 Posts
Discussion Starter #1
I have purchased a pair of the original tie down brackets with original bolts and dome shaped washers to fit on my 64.5.

My questions are,

Which way do the bolts mount, nuts to the guard or to the fuel tank.

Which end does the washer mount to, the bolt head or the nut end?

Which one goes on which side?




 

·
Registered
Joined
·
5,493 Posts
Guessing you 64.5 is a single exhaust car. Those "shorter" shipping brkts are correct.
If someone has a car with dual exhaust, they'll need to use the Ford longer brkts like I had to use on my 67.
Just noting for all that read, there was two diff sizes.
 

·
Registered
Joined
·
327 Posts
The head of bolt and bracket goes on inside, only bolt on outside. Of course, one bolt on bottom. The sweep goes to rear of car as well. Just looked at my 65.
 
1 - 7 of 7 Posts
Top