Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
7,944 Posts
I'm not certain if the 66 are the same as the 65, but on my 65 there were two nuts that attached the bezel (5/16 I think) and the actual switch was also held on by the nuts. One at the top and one at the bottom on the back of the dash. (So froma cross section it went bezel, dash sheet metal, switch, and then the nuts). Hope that helps.

John Harvey
 
1 - 3 of 3 Posts
Top