Vintage Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hey guys, I've got a bit of a Frankenstein going on with this 66 200 that I redid for my wife. I've got the 2.77 Ford toploader behind the 200 I6. The car has the 9" flywheel on it, but it has the small 15/16" shaft on the trans that would normally go with the 8.5" clutch. The flywheels are completely different between the 8.5" and 9". I had installed the smaller throwout bearing and tried to drive it, but the whole car shivered and shook when i would let out on the clutch. Is there any kind of hybrid throwout bearing or 3bolt throwout shaft with a 1 1/16" neck on it? Thanks in advance.
 

Attachments

1 - 1 of 1 Posts
Top