Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
73 Posts
Discussion Starter #1
Just got the front bench seat back for our 66 coupe. This is the TMI cover set and pads. The tops look out of square, but it's just the angle of the picture. TMI didn't show any seat bottom pads for the bench seats, so the originals were used. If you look closely, you can see that the bottoms are different from normal bucket seats. We had this work done at J and F Auto Upholstery in Indianapolis. I really believe they did a wonderful job. They cleaned the frames, replaced the burlap undercoat and went to extra effort to rebuild the center section and arm rest.
 

Attachments

·
Registered
Joined
·
59 Posts
Those look great.. I'm wondering why I'm cutting the inside foam off of the bucket seat cushions when the seat looks like it needs it to fill out the inside before the center section? Would it be better to just trim the under side of that piece a little?
 
1 - 2 of 2 Posts
Top