Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Somehow we've misplaced our templates to place the "GT" badges on a 66 in our shop. This is the last thing we need to get it back to the customer. Does anyone have a web address, measurement, diagram or picture that we can go by?
Thanks in advance_bob
 
G

·
Discussion Starter · #2 ·
I have my template. The lower hole is 2 15/16 inches above the top GT stripe, and 13.5 inches from the rear of front fender. The upper hole is 4 7/8 inches above the stripe and
13 3/8 inches from fender edge.

Steve O
 
1 - 3 of 3 Posts
Top