Vintage Mustang Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,483 Posts
You should find two. One will be drilled the size of a small post on the back side of your proportioning valve; and the other the size of the stubby little screw that bolts through the inner panel from the outside to secure the valve to the inner fender apron. they're about 3-4 inches back from the shock tower, about the same distance up from the frame rail if memory serves correct.
 

·
Registered
Joined
·
3,483 Posts
I believe the original location is down and to the rear from there.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top