Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
3,428 Posts
Discussion Starter #1
Anybody out there have an efficient way to bet the rollers back in the tracks on a 66 conv. I did get it done; but at about 3 hours I know ther has to be a better way. The horizontal was easy, it was the vertical (up/down) that was a pain.

Thanks
 

·
Registered
Joined
·
3,188 Posts
Are you talking about door glass or rear quarter? For the door glass the rollers are held onto the arms by removable clips. Slide the springy clips out and the arm detaches from the roller-leaving it in the track. To re-install, pop clip back into roller and push arms pin back through- clip locks back around- similar to the snap on door handles. The rear quarter glass are just a pain.
 

·
Premium Member
Joined
·
3,428 Posts
Discussion Starter #3
It is of course the rear! :p
 
1 - 3 of 3 Posts
Top