Vintage Mustang Forums banner

66 Shifter

818 4
Hi - I just bought a 66 GT Coupe. It has the factory 4 speed, with the finger pull reverse lockout. I think it is a T10 transmission. It seems like the shifter is really sloppy. Is there some kind of rebuild kit that I can buy that will have all the plastic bushings and stuff like that to restore the shifter?
Thanks!
1 - 1 of 1 Posts

· Registered
Joined
·
408 Posts
This will cure some of the slop. But a really worn shifter will have the "Lower" shifter that is pinned to the shift shaft worn as well. It is press fit to the shaft. Repros are available if needed.
To find out...remove the shift handle and move the lower shifter that the shift handle bolts to. It should pivot around the pin but not have any perceptable play from an enlongated hole.

Scott
National Parts Depot
1965 Conv:Street driven concours
1966 Coupe: Daily driver and toy
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top