Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3,102 Posts
Discussion Starter #1
Thanks for the previous replys and diagrams. Unfortunately, none of the diagrams or manuals for '65 or '66 show a single speed wiper switch WITH the pull to wash feature.

If anyone has this setup, I just need to know where the white washer power wire connects. One end plugs into the back of the wiper switch, the other has a male bullet connector. I can't figure out where it goes into the main wiring harness.

Thanks again for the assistance.
 

·
Registered
Joined
·
550 Posts
I don't think it does go through the main wiring. It is a separate wire feed through the firewall up to washer pump motor. Go up to to your pump motor and see if you have a wire there. Follow it back into dash and hook to your white one. Make sure you have +12V on that wire when wiper know is pulled... good luck! ::
 
1 - 3 of 3 Posts
Top