Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Premium Member
1967 Coupe
Joined
·
48 Posts
Discussion Starter #1
replacing the window regulators on my 67 coupe. The three track screws will have to be persuded out with a screw extractor. Does anyone know what screw size these screws are so I can get some replacements?
 

·
Registered
Joined
·
72 Posts
I'm not completely certain these are the screws you are referring to. If they are the three screws that attach the window guide along the bottom of the window (which do sometimes require a screw extractor to remove), these are the correct screws.

 

·
Premium Member
1967 Coupe
Joined
·
48 Posts
Discussion Starter #3
I'm not completely certain these are the screws you are referring to. If they are the three screws that attach the window guide along the bottom of the window (which do sometimes require a screw extractor to remove), these are the correct screws.

Yup, they are the ones. Didn’t see them when I looked before
Thank you
 

·
Premium Member
1967 Coupe
Joined
·
48 Posts
Discussion Starter #5
Looking back at my blog post when I did that, I noted they were 8-32 x 1/2″ flat head, counter-sunk. about a buck at the local hardware store. I also found the J clips on amazon for a box of 50 cheaper than that whole kit. Doors – Most annoying. So far.
That is what I was looking for, thank you
 
1 - 5 of 5 Posts
Top