Vintage Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
952 Posts
Discussion Starter #1
Has anyone had any experience with the repro aprons? Specifically I need the drivers rear apron. My hood bolts are rusted out and the Body shop needs to weld in a patch. I don't think redoing the whole apron is necessary just several inches around the hood bolts. I hear the repros are not very good for doing this and I would be better served getting some OEM ones from a parts car. What is your experience? Also how about repro hinges, I will need to replace those also?
 

·
Registered
Joined
·
2,402 Posts
The repop I put on mine used round nuts for the hinge mounts, not the square ones. For my car, It didn't matter, but for yours it might.
I can also be sure that the fit will not be the same.
 
1 - 4 of 4 Posts
Top