[janschutz]

I adding the deluxe door grills to my 68. I have a 67 deluxe door shell I am using as a template so I know where all the holes belong in the door. The only place I can figure out for the wiring for the door light is the dimple right under the door jam switch. Is this correct.
Also when I am done transferring the template, I will be getting rid of the 67 driver’s door shell (no bondo or rust). Would $125 be a good selling price?

 

[janschutz]

My post are getting cut off at 500 characters - anone else have this problem?

the rest of the of above post

... I am thinking that I will give most of the proceeds to VMF (Bob) after I recouping my $25 cost and I want to maximize the donation.

 

[GTClown]

http://a9.cpimg.com/image/1B/53/36643099-f2d5-02000155-.jpg
Not a good pic. The wire/s enter through a grommet about two inches directly below the bottom bolt on the door's hinge. There's a dimple towards the inside of the door that's undisturbed.