Vintage Mustang Forums banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
4,928 Posts
Discussion Starter · #1 ·
If someone has a moment ..could they give me a measurement from the quarter extension (where it meets the quarter panel) to the rear reflector. I want to mount the reflectors and since we put on new quarters .....I don't have any holes to go by ...thanks!
 

·
Registered
Joined
·
683 Posts
My reflectors are off, so here are the measurements to the holes for the reflector. As you requested, from the joint where the quarter meets the extension - the rear hole is 2 5/16" to center, the front hole is 7 7/8" to center. Holes are 1/4" diameter.

I took no vertical measurement. Hope this helps.
 

·
Registered
Joined
·
3,628 Posts
on my '68 coupe it is 1 in. from ext to point of reflector and the top of the reflector is 14.5 in. from trunk deck gooing across top of qtr down to top of reflector with flexible ruler. PM me if need more.
 

·
Premium Member
Joined
·
4,928 Posts
Discussion Starter · #4 ·
Thankyou for the help! Ken
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top