Vintage Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
326 Posts
Discussion Starter #1
I went to order my vintage wheel works rims today and they are back order, the guy at MU told me to check out there new rims, pictured here
http://www.mustangsunlimited.com/itemdy00.asp?T1=MW71A+01

They are dirt cheap, and a one piece rim. I very skeptical of the price but the guy said they he sold about 15 sets so far and haven't had any complaints. For under $500 I figure I cant really loose.

Anyone seen these before?
Anyone seen a pic of one on a car?

Please leave any feedback
 

·
Registered
Joined
·
8,661 Posts
Looks like a Boss 338 wheel knockoff, just with a pointier spoke. They both have the lip around the edge of each spoke, something not seen on the normal Bullitt rim. I love the Boss rims but 18" is as small as they go and 17" is what I want.



I would think 4.75" is getting a bit close to the ball joint. You can get the 4.75" rim and if it is too close you can buy a 1/4" wheel spacer. You can decrease the backspacing with a spacer, but you can't add backspacing.
 
1 - 6 of 6 Posts
Top