Vintage Mustang Forums banner

68 Project Coming To A End.

Jump to Latest Follow

1 - 3 of 3 Posts
Cruzer

·
Registered
Joined
·
4,082 Posts
Discussion Starter • #1 •
Got the 68 painted, now working on the interior. Painted the dash last night. Next I'll start putting new dash parts & everything back in this week. New carpet, seats, door panels etc... I've been taking pics as I go & will post them probably at the end of the week. Had to step up my schedule after our son called Sunday morning saying he was coming home early. He's in Pakastan in the USAF. He'll be landing in Charlotte,NC Tuesday!!!!!!
 
J

·
Registered
Joined
·
2,724 Posts
#2 •
Congrats, I wish I could sau the same for my 68s.
 
F

·
Registered
Joined
·
804 Posts
#3 •
People like you writing posts like this keep me working on my car!!! If I didin't hear of others finishing the cars (as well as their goals) I don't know how far my car would be done!!! All I can say is.... Keep Going!!!
 
1 - 3 of 3 Posts
Recommended Reading
Read More

  1. Bad Gas, What now?

    Vintage Mustang Forum
    So, I'm a bit uncertain of how long my 66 car sat before I obtained it. But I know for sure it was atleast 3 years. How many times it was ran, I'm not sure. Anyhow, after a small carb mishap (some of you may have seen my other thread), I noticed when I tore the carb down there was a significant...

  2. “Hidden” or massless antennae?

    Vintage Mustang Forum
    Hey everyone. So I was planning to weld up the antenna hole for a clean looking fender, but now I’m having second thoughts because I do like to use my radio for actual FM music... but then my body worked uncharacteristically fast and welded up the hole before I got a chance to tell them not to...

  3. Trying to determine what front spring rate I need. Where do I start?

    Vintage Mustang Forum
    Ok, To clarify...this is why I am asking: This is the car with the engine and trans in place...fenders and other body pieces on the front clip are not yet on...but I don't think all that is going to change things by more than about 50lbs. Now obviously the car is far from the point of being...

  5. Flywheel

    Vintage Mustang Forum
    Hello, I am replacing my clutch and all linkages on my 69 convertible in a few weeks. The mechanic thinks that the flywheel may need to be replaced at that time., but we are not sure until he gets into it. We don’t know if the current flywheel was resurfaced 1 or a couple of times. Due to...

  6. Low Compression. What would you do ?

    Vintage Mustang Forum
    Ive had a vibration in my 200 6 cyl engine that comes in between 1100-1500 rpm. I can even feel it in the steering wheel while driving. The engine idles well and runs fine otherwise although fuel milage is only 16 MPG. New plugs, points, wires, cap, rotor, coil, rebuilt carb, recurved...
Read More
About this Discussion
2 Replies
3 Participants
Last post:
Flyinford
Vintage Mustang Forums
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!
Full Forum Listing
Explore Our Forums
Vintage Mustang Forum General Discussion (Non-Vintage Mustang) Mod and Custom Forum Classic Mustang Wanted Ads Concours Forum
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Top