Vintage Mustang Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My 68 Fastback has bent rear frame rails. I want to replace them but don't know how to line up the new ones. Is there a resource with proper measurements, like, distance between rails, length, height, etc...? Does anyone know of an entire frame assembly that could be installed?
 

·
Registered
Joined
·
1,579 Posts
If you were local I'd bring my 68 over and let you make real time measurements. A comparable car right beside yours would be a great way to do it.
Measure, tack, double check measurements and make the final welds.
That would be a lot less tricky than using a book.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top