Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
406 Posts
Discussion Starter · #1 ·
All,

Here is a picture of an original 68 GT 350 carb spacer plate.

http://personal.rdu.bellsouth.net/~pdeamorg/shelby carb spacer.JPG

Here is a picture of the Boss 320 carb spacer plate.

http://personal.rdu.bellsouth.net/~pdeamorg/boss carb spacer.JPG

Both plates are the exact same thickness, the same outer dimensions/pattern, and the same PCV tube diameter. The difference is the center pattern (no impact to carb performance) and the shape of the PCV tube. If you cut the Boss carb plate PCV tube at 1.5" in length, it will have the same appearance as the original and will function the same.

Regards,
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top