Vintage Mustang Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
636 Posts
Discussion Starter · #1 ·
I have a 4 speed toploader with the original 68 shifter with the reverse lockout lever (the lever that must be pulled to get the tranny into reverse). Its not the T-bar style lockout lever, its the disk shaped lockout lever. Presently, there's a pin holding the disk shaped lockout lever to the shifter arm, and it's about 1 inch too long so it sticks out on both ends. I'm sure this is not the correct type pin. Does anyone know which pin is correct? How is the disk held in there???

Thanks!

Thespazardman
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top