68 torque box installation
1 - 3 of 3 Posts
Joined
·
1,869 Posts
you have to separate the two peices then weld them back together in place.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
How to avoid a money pit... (disregard title)
Vintage Mustang ForumOk I’m going to try and make this very loaded question alittle less loaded. Right now I’m a college student on a hard budget. Makes things difficult. I’ve heard so many say they wish they dropped the cash on this or that instead of cheaping out. I want to know where I can cheap out and where I...- 96
- 1K
-
Jr_Palm · updated
-
Issue with upper control arm removal :/
Vintage Mustang ForumHi Guys, I seemed to have run into an issue regarding the coil spring and removing the upper control arm on my '68. Can I use a macpherson spring compressor to pull up the bottom coil?- 8
- 202
-
65 Door Hinge is binding during close
Vintage Mustang ForumMy driver's side door hinge is binding and requires a big pull to get it shut. It makes a big popping noise when it finally closes. I've had the car for a month and it's done it ever since I bought the car. I've been focusing on getting the engine tuned and a leak fixed which I've...- 6
- 123
-
Keep or lose spring guard and bump stop?
Vintage Mustang ForumDoing body work now and going to paint the engine compartment and wheel wells soon, so I’m wondering if I should remove the large panel covering the top of the coil spring? Or is that a terrible idea? I have future plans for coil overs, but for now I will just be upgrading stock style...- 6
- 76
-
ianellis · updated
-
Will Eldelbrock Air Gap Intake #7581 on my 351w fit under a 69 mustang stock hood?
Vintage Mustang ForumI purchased Eldelbrock top end kit #2092 for my 351w in my 69 mustang. But in reading the fine print I learned this may not fit using a stock hood on some mustang models. I called and they said the kit comes with an air Gap intake that's 5.75 height. I ask about using a dropped air cleaner, They...- 1
- 46
Join now to ask and comment!