Vintage Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter #1
Anybody have a good photo of a 69 mach 1 quarter panel, specificaly the area under the side scoop. Redoing a R code that was requarterer 15 or so years ago, with a bunch of filler. Trying to get it right.
 

·
Registered
Joined
·
30 Posts
Discussion Starter #3
Thanks, 22gt. Do you know the car in the photo? has it been requarted, or repaired? We have repro quarters with a defined crease in the concave under the scoop. I don't think its correct, but don't know for sure. It's gotten to be a bit of an issue, to the owner.
 

·
Registered
Joined
·
1,528 Posts
That area is a pain to get right. My '69 was messed up on the driver's side quarter in that same spot. There is supposed to be a defined crease there. We verified this by looking at two original Machs with original quarters. Again, the area just doesn't look or "feel" (to use a bodywork term) the way you'd expect it to by glancing at it.
 

·
Registered
Joined
·
35,876 Posts
I saw this car being redone. This was right before repro 69 quarters became available.

 
1 - 6 of 6 Posts
Top