Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
655 Posts
Discussion Starter #1
Could someone run their tape over the rear seat backrest?I need the width of the backrest on a '69 Sportsroof,with the standard, non fold down setup.Also how close is it,either side, to your Quarter Trim Panels?
Greg

Never go into a Battle of Wits Unarmed!

http://albums.photopoint.com/j/View?u=1589603&a=12101731&p=43846223.jpg
Regards From the Great South Land.
 

·
Registered
Joined
·
6,807 Posts
Seat back frame is 3' 4 1/2" the seat cushion is 1 1/2" narrower on each side and the clearance between the frame and quarter panel trim is approx 1/8-1/4 "

Hope this helps

Jeff Speegle
MCA Shelby Gold Card

http://www.geocities.com/MotorCity/6473
Mustang & Shelby research, documentation

http://albums.photopoint.com/j/View?u=1609818&a=12284202&p=44925357&Sequence=7&res=high.jpg
 

·
Registered
Joined
·
655 Posts
Discussion Starter #3
Thank's Jeff,I was beginning to think there were no '69's over there with the standard rear seats!
Greg.

Never go into a Battle of Wits Unarmed!

http://albums.photopoint.com/j/View?u=1589603&a=12101731&p=43846223.jpg
Regards From the Great South Land.
 
1 - 3 of 3 Posts
Top