Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
143 Posts
Discussion Starter #1
I am almost positive but I just want to make sure that a 3rd member from a 68 stang 9" will fit in a housing from a 66 stang 9". I know the housings are different, but the pumpkin is the same right?

Tim
 

·
Registered
Joined
·
2,001 Posts
Dont forget, the axle spline count has to match too. I wouldnt expect you to have a 31 spline center in a 68, but if someone swapped it, you'll need axles to match.
 

·
Registered
Joined
·
7,671 Posts
And not to forget the pinion yoke. Several different U-joints could be used in a Mustang 9"...

Also a short and a long pinion yoke.
 
1 - 5 of 5 Posts
Top