Vintage Mustang Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
455 Posts
The pins are simple to remove.Install a screw,than using a pair of ****'s and a screw driver(as a pivot under the ****'s)pry the pin out.It is not threded on the outside.Make sure you have the column in the furthest up position when you remove the pins.Also remove the C clip from the top of the shaft so you can gain enough room to install the wishhbone.Another hint...don't remove the rod or switch.Cut the wishbone to remove the pin and reinstall it in the newone with a pair of plyers.If you run into any more prob's Email me.Good luck.
 

·
Registered
Joined
·
455 Posts
Forget the junkyard,you can still get them from ford,and a new one will last longer.
 
1 - 2 of 2 Posts
Top