Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 4 of 4 Posts

Discussion Starter · #1 ·
I just picked up an Edelbrock Performer Intake and matching 4-bbl for my 67 C-code. Can anyone tell me if my stock air cleaner will clear the hood with this combination? I would prefer to stick with the stock air cleaner/snorkle if possible.



'67 Conv. 289 C-code Frost Turquise
'99 Ford F250 Super Duty 4x4
'01 Ford Escape (wife's car)

1,135 Posts
I would think it should, I have the same set up but i have a Hipo type air cleaner which is pretty skinny. I had a three or four inch filter on there before and didn't have any problems. good luck.

AKA "Fastbackpimp"
[color:blue]VMF Member Since Nov. 99</font color=blue>

Discussion Starter · #3 ·
it will fit, I'm was running that intake manifold and stock air cleaner in my 67 until i switched in an open element

67 coupe, 289
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.